D-Link Unified Access Point Administrator's Guide
Table 35. Status Commands
Action
Get neighboring access points
Get information about switches that
can discover and manage the AP
Ethernet Settings
Use the commands in this section to view and set values for the Ethernet (wired) interface.
NOTE: Before configuring this feature, make sure you are familiar with the names of
Table 36. Ethernet Setting Commands
Action
Get Summary View of Internal
Interfaces
Get the DNS Name
Set the DNS Name
Get Current Settings for the
Ethernet (Wired) Internal Interface
Set the management VLAN ID
View untagged VLAN information
Enable the untagged VLAN
Disable the untagged VLAN
Set the untagged VLAN ID
View the connection type
Use DHCP as the connection type
Use a Static IP as the connection
type
Set the Static IP address
Set a Subnet Mask
Set the Default
Gateway
136
© 2001-2008 D-Link Corporation. All Rights Reserved.
the interfaces as described in
The interface name you reference in a command determines whether a setting
applies to a wired or wireless interface, the Internal network, or to radio
"one" or radio "two".
Command
get detected-ap detail
get managed-ap
"Interface Naming Conventions"
Command
get bss
get host id
set host id <host_name>
For example:
set host id vicky-ap
get management
set management vlan-id <1-4094>
get untagged-vlan
set untagged-vlan status up
set untagged-vlan status down
set untagged-vlan vlan-id <1-4094>
get management dhcp-status
set management dhcp-client status up
set management dhcp-client status down
set management static-ip <ip_address>
Example:
set management static-ip 10.10.12.221
set management static-mask <netmask>
Example:
set management static-mask 255.0.0.0
set static-ip-route gateway <ip_address>
Example:
set static-ip-route gateway 10.10.12.1
on page 132.