D-Link DWL-3500AP - AirPremier Wireless Switching 108G Access Point Administrator's Manual page 144

D-Link Unified Access Point Administrator's Guide
characters to a maximum of 63 characters. Following are two examples; the first sets the
key to "
DLINK-AP#
or
DLINK-AP#
Shared secret keys can include spaces and special characters if the key is placed inside
quotation marks as in the first example above. If the key is a string of characters with no
spaces or special characters in it, the quotation marks are not necessary as in the second
example above.
5. View the security settings.
Use the "get" command to view the updated security configuration and see the results of
the new settings.
DLINK-AP#
The following command gets details about how the internal network is configured,
including security details.
DLINK-AP#
The following command gets details about the interface and shows the WEP Key settings,
specifically.
DLINK-AP#
Set Security to WPA/WPA2 Enterprise (RADIUS)
To configure WPA/WPA2 Enterprise as the security mode, you need to issue multiple
commands. This section describes the commands and procedures to configure WPA/WPA2
Enterprise.
NOTE: This example shows how to configure WPA/WPA2 Personal on VAP 0 on
1. Set the Security Mode
DLINK-AP#
2. Set the WPA versions based on what types of client stations you want to support.
-
-
144 © 2001-2008 D-Link Corporation. All Rights Reserved.
", the second sets the key to "
SeCret !
set interface wlan0 wpa-personal-key "SeCret !"
set interface wlan0 wpa-personal-key KeepSecret
get interface wlan0 security
get bss wlan0bssvap0 detail
get interface wlan0 detail
radio 1 ( ). For VAPs 1-7, use
wlan0
the VAP ID. For example, to configure security on VAP 3 on radio 2, use
instead of
wlan1vap3 wlan0
set interface wlan0 security wpa-enterprise
WPA—If all client stations on the network support the original WPA but none support
the newer WPA2, then use WPA.
set bss wlan0bssvap0 wpa-allowed on
set bss wlan0bssvap0 wpa2-allowed off
WPA2—If all client stations on the network support WPA2, we suggest using WPA2
which provides the best security per the IEEE 802.11i standard.
set bss wlan0bssvap0 wpa-allowed off
set bss wlan0bssvap0 wpa2-allowed on
KeepSecret
, where
wlanxvapy
in all of the following commands.
".
is the radio, and is
x y