Time; System Management - D-Link DWL-3500AP - AirPremier Wireless Switching 108G Access Point Administrator's Manual

Time

Table 44 shows the commands you use to view the system uptime and to enable and manage
the Network Time Protocol (NTP) server on the access point.
Table 44. Time Related Commands
Action
View the system
uptime
View NTP server
settings
Enable the NTP
Server
Disable the NTP
server
Set the NTP server
hostname or IP
address

System Management

Table 45 shows the commands you use to manage the configuration file and firmware on the
AP.
Table 45. System Management
Action
Restore the factory default
settings
Save the configuration to a
backup file
Restore the configuration
from a previously saved file
Reboot the system
Upgrade the firmware
(requires a reboot)
Command
uptime
get ntp detail
set ntp status up
set ntp status down
set ntp-server server [<hostname> | <ip_address>]
Example:
set ntp-server server time.foo.com
or
set ntp-server server 192.168.34.201
Command
factory-reset
config download <url>
Example:
config download tftp://1.2.3.4/defaultcfg.xml
config upload <url>
Example:
config upload tftp://1.2.3.4/defaultcfg.xml
reboot
firmware-upgrade <url>
Example:
firmware-upgrade tftp://1.2.3.4/upgrade.tar
firmware-upgrade file://1.2.3.4/tmp/upgrade.tar
B CLI for AP Configuration
Access Point CLI Commands 149