Ethernet Settings; Table 7: Ethernet Settings Commands - D-Link DWL-6600AP Cli Command Reference

D-Link UAP CLI Command Reference

Ethernet Settings

Use the commands in this section to view and set values for the Ethernet (wired) interface.
Note: Before configuring this feature, make sure you are familiar with the names of the interfaces as
described in "Interface Naming Conventions" on page
command determines whether a setting applies to a wired or wireless interface, the Internal network,
or to radio "one" or radio "two"
Action
Get a summary view of internal
interfaces
Get the DNS host name for the AP.
Set the DNS host name for the AP.
Get current settings for the Ethernet
(wired) internal interface.
Set the management VLAN ID.
View untagged VLAN information.
Enable the untagged VLAN.
Disable the untagged VLAN.
Set the untagged VLAN ID.
View the connection type.
Use DHCP as the connection type.
Use a static IP as the connection type.
Set the static IP address.
Set a subnet mask.
Set the default gateway.
View the DNS name server mode:
Dynamic — up
Manual — down
D-Link
November 7, 2011

Table 7: Ethernet Settings Commands

Command
get bss
get host id
set host id host_name
Example:
set host id vicky-ap
get management
set management vlan-id 1-4096
get untagged-vlan
set untagged-vlan status up
set untagged-vlan status down
set untagged-vlan vlan-id 1-4096
get management dhcp-status
set management dhcp-status up
set management dhcp-status down
set management static-ip ip_address
Example:
set management static-ip 10.10.12.221
set management static-mask netmask
Example:
set management static-mask 255.255.255.0
set static-ip-route gateway ip_address
Example:
set static-ip-route gateway 10.10.12.1
get host dns-via-dhcp
20. The interface name you reference in a
Unified Wired and Wireless Access System
Ethernet Settings
Page 25