Wireless Interface; Table 37. Wireless Setting Commands - D-Link DWL-3500AP - AirPremier Wireless Switching 108G Access Point Administrator's Manual

Table 36. Ethernet Setting Commands
Action
View the DNS Nameserver mode
Dynamic= up
Manual=down
Set DNS Nameservers to Use
Static IP Addresses (Dynamic to
Manual Mode)
Set DNS Nameservers to Use
DHCP IP Addressing (Manual to
Dynamic Mode)

Wireless Interface

To set up a wireless (radio) interface, configure the Radio Mode and Radio
interface. The commands in this table use radio 1 (
radio 2, use
wlan1

Table 37. Wireless Setting Commands

Action
Enable or Disable 802.11d regulatory
domain support
Enable or Disable Station Isolation
View the current radio mode
Set the radio mode to Dynamic Turbo 5
GHz
Set the radio mode to Dynamic Turbo 2.4
GHz
View the radio channel.
Set the radio channel to a static channel.
Set the radio channel to "Auto"
Command
get host dns-via-dhcp
set host dns-via-dhcp down
set host static-dns-1 <ip_address>
set host static-dns-2 <ip_address>
Example:
set host static-dns-1 192.168.23.45
set host dns-via-dhcp up
.
B CLI for AP Configuration
). To change the wireless settings for
wlan0
Command
set dot11 dot11d up
set dot11 dot11d down
set radio wlan0 station-isolation on
set radio wlan0 station-isolation off
get radio wlan0 mode
set radio wlan0 mode dynamic-turbo-a
(only applicable for radio interface
wlan0)
set radio wlan0 mode dynamic-turbo-g
(only applicable for radio interface
wlan1)
get radio wlan0 channel
set radio wlan0 channel-policy static
set radio wlan0 static-channel <channel>
set radio wlan0 channel-policy best
Access Point CLI Commands
Channel on each
137