D-Link DWL-3500AP - AirPremier Wireless Switching 108G Access Point Administrator's Manual page 109

To use this type of security, you must perform the following steps:
1. Add the access point to the list of RADIUS server clients. (See
Server for Authentication"
2. Configure the access point to use your RADIUS server (by providing the RADIUS server
IP address as part of the "IEEE 802.1X" security mode settings).
3. Configure wireless clients to use IEEE 802.1X security and "Smart Card or other
Certificate" as described in this section.
4. Obtain a certificate for this client as described in
Client"
If you configured the access point to use IEEE 802.1X security mode with an external
RADIUS server, perform the following steps:
1. Configure IEEE 802.1X security with certificate authentication on each client as follows.
Choose WEP
Choose Open
Data Encryption mode
1
on page 116.)
on page 119.
Enable (click to check) IEEE 8021x authentication
Choose Smart Card/Certificate
Enable auto
key option
A Wireless Client Settings and RADIUS Server Setup
"Obtaining a TLS-EAP Certificate for a
2
Configuring IEEE 802.1X Security on a Client
"Configuring the RADIUS
...then, click "Properties"
109