Programming A Tone Frequency; Control Operation - Kenwood TM-D710A Manual

PROGRAMMING A TONE FREQUENCY

On receiving a tone from the Commander, the Transporter
causes the HF transceiver to enter Transmit mode. On
both the Commander and Transporter, access Menu 702
and select the desired, same tone frequency.

CONTROL OPERATION

When in the Sky Command mode, the Microphone keys
of the Commander will function as below. First switch
ON the HF transceiver and press Microphone [0] on the
Commander.
Each time you press the desired key, the Commander
will automatically enter transmit mode and send the
corresponding control command to the Transporter.
Key
[1] (PWR)
[2] (RX)
[3] (MODE)
[4] (RIT)
[5] (XIT)
[6] (CLR)
[7] (SPLIT)
[8] (M>V)
[9] (A/B)
[0] (SYNC)
[A] (MONI)
[B] (M/V)
[C] (UP)
[D] (DOWN)
[ ] (FAST)
1
[#]
2
(ENTER)
[PTT]
"FS" appears when you select 1 kHz step (LSB/ USB/ CW) or 10 kHz
1
step (FM/ AM).
After pressing Mic [#], press Mic [0] to [9] to enter a frequency or
2
memory channel number.
Note: To change the frequency or memory channel on the HF
transceiver, rotate the Tuning control.
SKY CMD-
Function
Power ON/ OFF
HF frequency receive ON/ OFF
Modulation mode switch
RIT ON/ OFF
XIT ON/ OFF
RIT offset or XIT offset clear
Split-frequency ON/ OFF
Transfer from Memory to VFO
In VFO mode: VFO A/ VFO B switch
In Memory Recall mode: no change
Current settings retrieve (from HF
transceiver)
To monitor the UHF band on the
Commander
VFO/ Memory Recall mode switch
XIT/ RIT offset frequency increase
XIT/ RIT offset frequency decrease
In LSB, USB, or CW mode: 10 Hz/ 1 kHz
switch
In FM or AM mode: 1 kHz/ 10 kHz switch
In VFO mode: frequency entry ON
In Memory Recall mode: channel number
entry ON
To transmit audio on an HF frequency