Table of Contents
Advertisement
PROGRAMMING CALLSIGNS
The built-in TNCs of the Commander and Transporter
communicate each other when you send a control command
from the Commander. So you must program different callsigns (9
digits max.) on these transceivers as the IDs of the TNCs.
Use the following Menu Nos. to program callsigns:
On Commander
COMMANDER
700
CALLSIGN
TRANSPORTER
701
CALLSIGN
On Transporter
COMMANDER
700
CALLSIGN
TRANSPORTER
701
CALLSIGN
1 Access Menu 700 or 701, then press the Tuning control.
•
The callsign entry fi eld appears; the fi rst digit blinks.
2 Rotate the Tuning control to select a character.
•
You can enter 0 to 9, A to Z, and –.
3 Press [].
•
The cursor moves to the next digit.
4 Repeat steps 2 and 3 to enter up to 9 digits.
[BACK]: Cancels entry of a callsign.
[]
: Causes the cursor to move backward.
[INS]: Inserts the currently selected character.
[CLR]: Deletes the digit at which the cursor is blinking.
5 Press the Tuning control to complete the setting.
6 Press [ESC] to exit Menu mode.
The keypad on the Microphone also is available to enter
alphanumeric characters in step 2.
PROGRAMMING A TONE FREQUENCY
On receiving a tone from the Commander, the Transporter
causes the HF transceiver to enter Transmit mode. On both the
Commander and Transporter, access Menu 702 and select the
desired, same tone frequency.
Callsign for Commander
Callsign for Transporter
Callsign for Commander
Callsign for Transporter
CONTROL OPERATION
When in the Sky Command mode, the Microphone keys of
the Commander will function as below. First switch ON the HF
transceiver and press Microphone [0] on the Commander.
Each time you press the desired key, the Commander will
automatically enter transmit mode and send the corresponding
control command to the Transporter.
Key
[1] (PWR)
[2] (RX)
[3] (MODE)
[4] (RIT)
[5] (XIT)
[6] (CLR)
[7] (SPLIT)
[8] (M>V)
[9] (A/B)
[0] (SYNC)
[A] (MONI)
[B] (M/V)
[C] (UP)
[D] (DOWN)
1
[ ]
(FAST)
[#]
2
(ENTER)
[PTT]
1
"FS" appears when you select 1 kHz step (LSB/ USB/ CW) or 10 kHz step (FM/
AM).
2
After pressing Mic [#], press Mic [0] to [9] to enter a frequency or memory
channel number.
Note: To change the frequency or memory channel on the HF transceiver,
rotate the Tuning control.
SKY CMD-3
Function
Power ON/ OFF
HF frequency receive ON/ OFF
Modulation mode switch
RIT ON/ OFF
XIT ON/ OFF
RIT offset or XIT offset clear
Split-frequency ON/ OFF
Transfer from Memory to VFO
In VFO mode: VFO A/ VFO B switch
In Memory Recall mode: no change
Current settings retrieve (from HF transceiver)
To monitor the UHF band on the
Commander
VFO/ Memory Recall mode switch
XIT/ RIT offset frequency increase
XIT/ RIT offset frequency decrease
In LSB, USB, or CW mode: 10 Hz/ 1 kHz
switch
In FM or AM mode: 1 kHz/ 10 kHz switch
In VFO mode: frequency entry ON
In Memory Recall mode: channel number
entry ON
To transmit audio on an HF frequency
Advertisement
Table of Contents
