Telephone Base And Charger Installation - AT&T EL51200 User Manual

Getting started

Telephone base and charger installation

If you subscribe to high-speed Internet service (DSL - digital subscriber line)
through your telephone line, you must install a DSL filter between the telephone
line cord and the telephone wall jack. The filter prevents noise and caller ID
problems caused by DSL interference. Please contact your DSL service provider
for more information about DSL filters.
The telephone base comes ready for tabletop use. If you want to mount your
telephone on a wall, refer to Wall mount installation on page 7 for details.
Electrical outlet not
controlled by a wall
switch
Plug the large end of
the telephone base
power adapter into
an electrical outlet
not controlled by a
wall switch.
Plug the small end
of the telephone
base power adapter
into the power jack
on the bottom of the
telephone base.
Plug the large end
of the charger power
adapter into an
electrical outlet not
controlled by a
wall switch.
Ensure the small end
of the charger power
adapter is plugged
into the power jack
on the bottom of the
charger.
DSL filter (not included) is
required if you have DSL
high-speed Internet service.
Telephone line cord
IMPORTANT INFORMATION:
Use only the power adapters provided with this
product. To obtain a replacement, visit our website at
www.telephones.att.com
1 (866) 288-4268
4
Telephone wall jack
Plug the other end of
the telephone line cord
into a telephone wall
jack.
Route the cords
through the slots.
Plug one end of the
telephone line cord
into the TEL. LINE
jack on the bottom
of the telephone
base.
or call
.