Handset Locator - AT&T E5655 User Manual

91-000373-030-000_E5655_R4.qxd
>HANDSET LOCATOR
DISPLAY BASE ID
>DISPLAY BASE ID
DIAL TYPE
DIAL TYPE
TONE
11/1/2005 10:04 AM
Telephone Operation
Base settings

Handset Locator

This feature is used as an aid to locate the handset(s). It
can only be activated from the base. Press
and then press the
SELECT/MENU
the HANDSET LOCATOR option is shown. Press
. The screen on the base will show
SELECT/MENU
"PAGING ALL HANDSETS" and start the paging
tone at the handset(s) for 60 seconds.
To stop the paging tone, press
press any dial pad key on the handset or press
on the base.
NOTE: The handset ringer volume also determines the level of the pag-
ing tone. If the handset ringer volume level is set to off (0), that handset will
be silenced for all calls and paging (see page 17).
Display Base ID
Press and then press the
SELECT/MENU
until the DISPLAY BASE ID option is shown. Press
to show the base ID number. This num-
SELECT/MENU
ber can be used when adding, replacing, or re-register-
ing handsets (see page 46-48).
Dial Type
At this menu you can choose Tone or Pulse dialing. The
factory default setting is
only if you do not have touch-tone dialing service.
^V
Use the buttons to select
press to save your preference.
SELECT/MENU
NOTE: This sets the dial type for both the handset(s) and the base.
21
Page 21
^ V
or key until
,
PHONE SPEAKER
CLEAR
^
or
. Change this to
TONE PULSE
or
TONE PULSE
or
V
key
, then