Re-Registering A Handset - AT&T E5655 User Manual

91-000373-030-000_E5655_R4.qxd
Appendix Appendix

Re-Registering a handset

You can re-register handsets after de-registering from the base. Or you can re-register
handsets to a new base unit, if you have replaced your base unit for any reason.
To re-register a handset:
• Make sure your handset batteries are properly installed and charged.
• Your handset will display "ENTER BASE ID".
• On your handset enter the 15-digit Base ID number from the base menu (see page
46).
• Press
SELECT/MENU
tration.
To re-register a handset to a new base unit:
• Make sure your handset batteries are properly installed and charged.
• Unplug the old base unit. Your handset will display "SEARCHING...".
• Install the new base unit by plugging it into the electrical outlet and phone jack.
• Press and hold the
BASE ID".
• On your handset enter the 15-digit Base ID number from the base menu (see page
46).
• Press
SELECT/MENU
tration.
NOTE: If an invalid Base ID code is entered, you will hear an error tone and the handset will continue to display
"ENTER BASE ID". To make corrections while entering the code, you can erase digits by pressing the DELETE key.
Once a valid Base ID code is entered and accepted by the base unit, the new handset
will be assigned the next available handset number. You can register a maximum of
four handsets per base unit.
11/1/2005
on the handset to accept the new code and complete re-regis-
key on the handset until you see "ENTER
SELECT/MENU
on the handset to accept the new code and complete re-regis-
48
10:09 AM Page 48