Xerox DocuColor 252 User Manual page 228

220
9. A system message may appear requesting you to restart the computer.
a. Exit the Spire CX260 software.
b. Click Yes to restart your computer.
Restoring the Factory Default Configuration
To restore the Factory Default configuration, the operating system must be in
Factory Default mode. See Verifying the Current Recovery Type on page 217.
Note: The Spire CX260 default backup configuration is the Last Image
configuration.
1. Exit the Spire CX260 software and wait for the Spire icon to disappear from the
desktop taskbar.
Taskbar with Spire icon
2. Using the tip of a pen or similar object, push the RCVR button on the Spire
CX260.
Note: If you only want to verify the current recovery type, but do not want
to initiate the recovery process, push the RCVR button again to exit the
recovery mode (LED 7 turns off).
3. From your Windows-based computer, Macintosh computer, or portable
workstation, connect to the Spire CX260 via the RDC utility. See Working from
the Remote Desktop Application on page 86.
Note: This step is required only for the CX260 basic configuration.
4. When the RCVR LED (7) illuminates steady orange, go to Start > CX260 >
CX260 Tools > System Backup and Restore > Set Factory Default recovery.
5. When the operating system confirmation message appears, click OK.
6. Push the green On/Off button to restart the Spire CX260.
Norton Ghost copies the files from partition E to partitions C and D. This
process takes approximately 10-15 minutes.
Chapter 9 – Reinstalling the Spire CX260
Taskbar without Spire icon