The Calibration Window - Xerox DocuColor 252 User Manual

Calibration

The Calibration Window

Step 3 of the Color Calibration Wizard appears.
14. Select Save as and select the required name for the calibration table. Do one of
the following:
•
Type your own or select one from the list.
•
Select As default table (Normal) to save the calibration table as Normal.
Note: Each time you save a calibration table as default, it is saved twice,
once as Normal look up table, and once as the Saturated look up table. The
Spire CX260 automatically overwrites the existing
calibration tables.
Tip: It is strongly recommended that you include the specific paper name
and screen method in the calibration table file name. This helps you select
the correct calibration table in the job setup.
15. Click Finish.
One calibration table is saved:
•
Normal—A table that maintains the gray balance throughout the range of
colors in the print job file
The Calibration window enables you to create and edit calibration tables. You can
use the Color Calibration Wizard to create a calibration table, or edit an existing
calibration table.
The Color Calibration Wizard analyzes the measurements and creates calibration
tables. Using these tables, the Spire CX260 compensates for the difference between
the printer's performance and the required values.
The following calibration look-up tables are provided:
•
None: Applies no calibration table to the job.
Normal and Saturated
131