Cf_Keydis Command; Cf_Fdefault Command; Cf_Pjpincode Command; Cf_Testpat Command - Sanyo PLC-ET30L - 4200 Lumens Specifications

PLC-ET30L Expand Serial Command Functional Specifications

8.10.15 CF_KEYDIS Command

Command "CF_KEYDIS_%1" [CR]
"NONE" ---------------------- RC & Projector keys are valid (All are valid)
"RCFULL" ------------------- All RC keys are invalid
%1 "RCPART" ------------------- Specific RC keys are invalid
"KEYFULL" ------------------ All projector keys are invalid
"KEYPART" ------------------ Specific projector keys are invalid
Set a ban on the use of RC keys/ projector keys
Details
(Available only in the normal Power ON status)
Acceptable
Response
Unacceptable

8.10.16 CF_FDEFAULT Command

Command "CF_FDEFAULT_%1" [CR]
%1 "RST"
Reset to Factory Default setting
Details
(Available only in the normal Power ON status)
Acceptable
Response
Unacceptable

8.10.17 CF_PJPINCODE Command

Command "CF_PJPINCODE_%1" [CR]
%1 "0000 – 9999" ------------- Directly specify PJ PIN code
Enter PIN code to cancel PIN code lock (Available only in the normal Power ON
status)
PIN code can not be changed. (Only PIN code lock is canceled.)
*When PIN code Lock is enabled:
PIN code is matched ------------------------- Command is valid (Acceptable)
PIN code is mismatched -------------------- Command is invalid (Error code "102")
PIN code is beyond %1 available range ------------ Command is invalid (Error
Details code "?")
When PIN code lock is canceled:
PIN code is within %1 range ----------- Command is valid (Acceptable)
PIN code is out of %1 range ----------- Command is invalid (Error code is 102)
This command is only valid when "PJ PIN code" dialog is displayed to enter PIN
code after Power is ON and Countdown is completed.
When PIN code lock is set to "On1", it needs to send this command every time
the projector is turned on.
Acceptable
Response
Unacceptable

8.10.18 CF_TESTPAT Command

Command "CF_TESTPAT_%1" [CR]
"COLOR" ---------------------- Display Color bar
"GRAD1" ---------------------- Display 16step(white→black)
"GRAD2" ---------------------- Display 16step(white←black)
"GRAD3" ---------------------- Display 16step(white↓black)
"GRAD4" ---------------------- Display 16step(white↑black)
%1 "WHITE" ---------------------- Display all white
"BALCK" ---------------------- Display all black
"CROSS" --------------------- Display Cross
"OFF" --------------------------Do not show test pattern diplay
"UP" --------------------------- Switch forward
"DN" ---------------------- Switch backward
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
35/62