Cf_P-Manetime Command; Cf_Fanspeed Command; Cf_Highland Command; Cf_Slant Command - Sanyo PLC-ET30L - 4200 Lumens Specifications

PLC-ET30L Expand Serial Command Functional Specifications

8.10.11 CF_P-MANETIME Command

Command "CF_P-MANETIME_%1" [CR]
"01" - "30" ----------------------- Directly specify setting time by the minute
"UP" -------------- Increment value by 1 (Switched in 01→02→ --- → 30 → 01 order)
%1
"DN" -------------- Decrement value by 1(Switched in 30→29→ --- → 01 → 30 order)
Set time of Power Management time (Available only in the normal Power ON
status)
Details
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.10.12 CF_FANSPEED Command

Command "CF_FANSPEED_%1" [CR]
"MAX" ------------------------------ Select maximum fan speed
%1
"NOR" ------------------------------ Select normal fan speed
Switch Fan Control Speed mode.(Available only in the normal Power ON status)
Details The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.10.13 CF_HIGHLAND Command

Command "CF_HIGHLAND_%1"[CR]
"ON" ----------------------- Set Highland mode to ON
%1
"OFF" ---------------------- Set Highland mode to OFF
Set/Cancel Highland mode. (Available only in the normal Power ON status)
Details The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF.
Acceptable
Response
Unacceptable

8.10.14 CF_SLANT Command

Command "CF_HIGHLAND_%1"[CR]
"OFF" --------------------- Install a projector without slant
"L1" ----------------------- Slant a projector at ? ~ ? degree angle
%1 "L2" ----------------------- Slant a projector at ? ~ ? degree angle
"UP" ---------------------- Switch forward (Off -> L1 -> L2 -> Off)
"DN" ---------------------- Switch backward (Off -> L2 -> L1 -> Off)
Switch slant of the projector installed.
(Available only in the normal Power ON status)
Details
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
34/62