Lamp Command Table; Sound Command Table; Setting Command Table; Other Command Table - Sanyo PLC-ET30L - 4200 Lumens Specifications

PLC-ET30L Expand Serial Command Functional Specifications

5.5 Lamp Command Table

Execute command
CF_LAMPH_%1 [CR]
CF_LAMPMODE_%1 [CR]

5.6 Sound Command Table

Execute command
CF_VOLUME_%1[CR]
CF_MUTE_%1[CR]

5.7 Setting Command Table

Execute command
CF_BACKGND_%1[CR]
CF_DISP_%1 [CR]
CF_LOGO_%1 [CR]
CF_CEIL_%1 [CR]
CF_REAR_%1 [CR]
CF_RCODE_%1 [CR]
CF_RCSENSOR_%1 [CR]
CF_LANG_%1 [CR]
CF_ON-STA_%1 [CR]
CF_P-MANE_%1 [CR]
CF_P-MANETIME_%1 [CR]
CF_FANSPEED_%1 [CR]
CF_HIGHLAND_%1[CR]
CF_SLANT_%1[CR]
CF_KEYDIS_%1 [CR]
CF_FDEFAULT_%1 [CR]
CF_PJPINCODE_%1[CR]
CF_TESTPAT_%1[CR]
CF_FILH_%1[CR]
CF_FILTIMER_%1[CR]
CF_POINTER_%1[CR]

5.8 Other Command Table

Execute command
CF_KEYEMU_%1 [CR]
CF_MENU_%1 [CR]
CF_POWER_%1 [CR]
CF_FREEZE_%1 [CR]
Reset total running time for each lamp
Select Lamp mode
Item
Set Volume value
Control ON/OFF of Sound Mute
Item
Select screen for no signal
Set ON/OFF of On Screen Display
Set PIN code and mode for Logo
Set ON/OFF of Ceiling
Set ON/OFF of Rear
Select Remote Control Code
Select location of infrared remote receiver of remote
control
Select language for OSD
Set ON/OFF of Power ON Start
Set Power Management function
Set time of Power Management
Set level of Fan Speed
Set Highland mode
Set slant of projector installed
Prohibit RC/KEY control
Reset to Factory Default settings
Enter PJ PIN code to cancel PJ lock
Set Test pattern display function
Reset Filter used time
Set time to display Filter cleaning / replacement warning
on screen
Set Pointer function
Item
The same operation as RC/Control Key
Set ON/OFF of Menu
Set ON/OFF of Power
Set ON/OFF of Freeze
Item
11/62