Cf_Hscale Command; Cf_Hpos Command - Sanyo PLC-ET30L - 4200 Lumens Specifications

PLC-ET30L Expand Serial Command Functional Specifications

8.7.7 CF_HSCALE Command

Command "CF_HSCALE_%1" [CR]
"032" ---------------------- +32
"031" ---------------------- +31
ÿ
"002" ---------------------- +2
"001" ---------------------- +1
"000" ---------------------- ±0
" 01" --------------------- 1
%1
" 02" --------------------- 2
ÿ
" 31" --------------------- 31
" 32" --------------------- 32
"UP" --------------------- Increment setting value of Hscale by 1
"DN" --------------------- Decrement setting value of Hscale by 1
Set Hscale (Available only in the normal Power ON status)
* When selected screen mode is not "Custom", error code "101" [CR] is returned
Details
and it is not executed.
* Error Code "101" [CR] is returned for no signal.
Acceptable
Response
Unacceptable

8.7.8 CF_HPOS Command

Command "CF_HPOS_%1" [CR]
"015" --------------------- +15
"014" --------------------- +14
ÿ
"002" --------------------- +2
"001" --------------------- +1
"000" --------------------- ±0
" 01" --------------------- 1
%1
" 02" --------------------- 2
ÿ
" 14" --------------------- 14
" 15" --------------------- 15
"UP" --------------------- Increment setting value of Hposition by 1
"DN" --------------------- Decrement setting value of Hposition by 1
Set H Position (Available only in the normal Power ON status)
* When selected screen mode is not "Custom", error code "101" [CR] is returned
Details
and it is not executed.
* Error Code "101" [CR] is returned for no signal.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
29/62