Adjusting The Sound - BenQ SP920 - XGA DLP Projector User Manual

Adjusting the sound

The sound adjustments made as below will have an effect on the projector speakers. Be sure you have made a
correct connection to the projector audio input. See
connected.
Muting the sound
To temporarily turn off the sound,
• Using the remote control
Press MUTE to temporarily turn off the sound. While the sound is off, the screen will
display in the upper right corner of the screen.
To restore the sound, press MUTE again.
• Using the OSD menu
1. Press MENU/EXIT and then press
menu is highlighted.
2. Press to highlight Audio Settings and press ENTER. The Audio Settings page
displays.
3. Highlight Mute and press
4. To restore the sound, repeat steps 1-3 and press
Adjusting the sound level
To adjust the sound level, press VOLUME+/VOLUME- on the remote control, or:
1. Repeat steps 1-2 above.
2. Press to highlight Volume and press
Turning off the Power on/off ring tone
To turn off the ring tone,
1. Repeat steps 1-2 above.
2. Press to highlight Power on/off ring tone and press
The only way to change Power on/off ring tone is setting On or Off here. Setting the sound mute or
changing the sound level will not affect the Power on/off ring tone.
38 Operation
"Connection" on page 16
/ until the SYSTEM SETUP: Advanced
/ to select On.
/ to select Off.
/ to select a desired sound level.
for how the audio input is
/ to select Off.