Adjusting The Sound - BenQ MW856UST User Manual

Adjusting the sound

The sound adjustments made as below will have an effect on the projector speakers. Be
sure you have made a correct connection to the projector audio input. See
on page 22 for how the audio input is connected.
INPUT SOURCE
Computer
HDMI/MHL
VIDEO
S-VIDEO
Muting the sound
To temporarily turn off the sound,
• Using the remote control
Press MUTE to temporarily turn off the sound. While the sound is off, the screen will
display in the upper right corner of the screen.
To restore the sound, press MUTE again.
• Using the OSD menu
1. Press MENU/EXIT and then press ◄/► until the System Setup: Advanced
menu is highlighted.
2. Press ▼ to highlight Audio Settings and press MODE/ENTER.
The Audio Settings page displays.
3. Highlight Mute and press ◄/► to select On.
4. To restore the sound, repeat steps 1-3 and press ◄/► to select Off.
Adjusting the sound level
To adjust the sound level,
• Using the remote control
Press or
• Using the OSD menu
1. Repeat steps 1-2 above.
2. Press ▼ to highlight Volume and press ◄/► to select a desired sound level.
Turning off the Power on/off ring tone
1. Repeat steps 1-2 above.
2. Press ▼ to highlight Power on/off ring tone and press ◄/► to select Off.
The only way to change Power on/off ring tone is setting On or Off here. Setting the sound mute
or changing the sound level will not affect the Power on/off ring tone.
Operation
AUDIO IN
to select a desired sound level.
mini jack
HDMI/MHL
RCA
RCA
"Connection"
AUDIO OUT
mini jack
mini jack
mini jack
mini jack
45