Description Of Each Menu - BenQ SP920 - XGA DLP Projector User Manual

Description of each menu

FUNCTION
Wall Color
Aspect Ratio
Keystone
Position
Phase
H. Size
Digital Zoom
Picture Mode
Reference Mode
Brightness
Contrast
Color
Tint
Sharpness
Brilliant Color
Color Temperature
3D Color
Management
Save Settings
DESCRIPTION
Corrects the projected picture's color when the projection surface is not
white. See "Using Wall Color" on page 31
There are four options to set the image's aspect ratio depending on your
input signal. See "Selecting the aspect ratio" on page 30
Corrects any keystoning of the image. See
29 for details.
Displays the position adjustment page. To move the projected image, use
the directional arrow keys. The values shown on the lower position of the
page change with every key press you made until they reach their
maximum or minimum.
This function is only available when a PC signal (analog RGB)
is selected.
Adjusts the clock phase to reduce image distortion.
This function is only available when a PC signal
(analog RGB) is selected.
Adjusts the horizontal width of the image.
This function is only available when a PC signal (analog RGB)
is selected.
Magnifies or reduces the projected image. See
for details" on page 29 for details.
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See
mode" on page 31 for details.
Selects a picture mode that most suits your need for the image quality and
further fine-tune the image based on the selections listed on the same
page below. See "Setting the User 1/User 2 mode" on page 32
Adjusts the brightness of the image. See
for details.
Adjusts the degree of difference between dark and light in the image. See
"Adjusting Contrast" on page 32
Adjusts the color saturation level -- the amount of each color in a video
image. See "Adjusting Color" on page 32
This function is only available when a Video or S-Video signal
is selected and the system format is NTSC or PAL.
Adjusts the red and green color tones of the image. See
on page 32 for details.
This function is only available when a Video or S-Video signal
is selected and the system format is NTSC.
Adjusts the image to make it look sharper or softer. See
Sharpness" on page 32 for details.
This function is only available when a Video or S-Video signal
is selected and the system format is NTSC or PAL.
See "Adjusting Brilliant Color" on page 33
See "Selecting a color temperature" on page 33
See "3D Color Management" on page 33
Saves the settings made for User 1 or User 2 mode.
for details.
for details.
"Correcting keystone" on page
"Magnifying and searching
"Selecting a picture
"Adjusting Brightness" on page 32
for details.
for details.
"Adjusting Tint"
"Adjusting
for details.
for details.
for details.
Operation
for details.
43