Table of Contents
Advertisement
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speakers. Be sure
you have made a correct connection to the projector audio input. See
15
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.
Press MENU/EXIT and then press
is highlighted.
2.
Press
page displays.
3.
Highlight Mute and press
Adjusting the sound level
To adjust the sound level, press VOLUME-/VOLUME+ or
1.
Repeat steps 1-2 above.
2.
Press
Turning off the Power On/Off Ring Tone
To turn off the ring tone:
1.
Repeat steps 1-2 above.
2.
Press
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
Shutting down the projector
1.
Press
If you don't respond in a few seconds, the message will disappear.
2.
Press
projection lamp shuts down, and the fans will continue to run for approximately 90
seconds to cool down the projector.
To protect the lamp, the projector will not respond to any commands during the cooling
process.
To shorten the cooling time, you can also activate the Quick cooling function. See
Cooling" on page 40
to highlight Audio Settings and press MODE/ENTER. The Audio Settings
/
to highlight Volume and press
to highlight Power On/Off Ring Tone and press
POWER and a confirmation message will display prompting you.
POWER a second time. The POWER indicator light flashes orange, the
for details.
/
until the SYSTEM SETUP: Advanced menu
to select On.
/
to select a desired sound level.
"Connection" on page
/
, or:
/
to select Off.
"Quick
Operation
33
Advertisement
Table of Contents
