Correcting Keystone; Magnifying And Searching For Details - BenQ SP920 - XGA DLP Projector User Manual

Correcting keystone

Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It
occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually correct it by following one
of these steps.
• Using the remote control
Press / on the control panel of the projector or remote
control to display the Keystone correction page. Press
keystoning at the top of the image. Press
the bottom of the image.
• Using the OSD menu
1. Press MENU/EXIT and then press
menu is highlighted.
2. Press to highlight Keystone and press ENTER. The Keystone
correction page displays.
3. Press to correct keystoning at the top of the image or press
to correct keystoning at the bottom of the image.
/ .
Press

Magnifying and searching for details

If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for
navigating the picture.
• Using the remote control
1. Press DIGITAL ZOOM +/- to display the Zoom bar.
2. Press DIGITAL ZOOM+ to magnify the center of the picture.
Press the key repeatedly until the picture size is suitable for your
need.
3. Use the directional arrows ( ,
remote control to navigate the picture.
4. To restore the picture to its original size, press AUTO. You can
also press DIGITAL ZOOM-. When the key is pressed again, the
picture is further reduced until it is restored to the original size.
• Using the OSD menu
1. Press MENU/EXIT and then press
menu is highlighted.
2. Press to highlight Digital Zoom and press ENTER. The
Zoom bar displays.
3. Repeat steps 2-4 in the section of
above. Or if you are using the projector control panel, continue
to the following steps.
4. Press on the projector repeatedly to magnify the picture to a
desired size.
5. To navigate the picture, press ENTER to switch to the paning mode and press the directional arrows ( ,
, , ) to navigate the picture.
6. To reduce size of the picture, press ENTER to switch back to the zoom in/out function, and press AUTO to
restore the picture to its original size. You can also press
to correct
to correct keystoning at
/ until the DISPLAY
/ .
Press
, , ) on the projector or
/ until the DISPLAY
"Using the remote control"
repeatedly until it is restored to the original size.
Keystone
MENU Back
The picture can only be
navigated after the picture is
magnified. You can further
magnify the picture while
searching for details.
Operation 29