Table of Contents
Advertisement
•
If one lamp fails, the projector enters Single-Alternative mode automatically. Dual-Brightest, Dual-
Single-Eco
Reliable and
•
After switching from Dual-Brightest/Dual-Reliable mode to Single-Alternative/Single-Eco mode or vice
versa, wait for 90 seconds before you can adjust the lamp mode again.
•
A slight variation in the picture brightness and colors may be observed during the very short time of
switching lamp modes.
Controlling the projector through a Lan
environment
Lan Control Settings allow you to manage the projector from a computer using a web browser when the
computer and the projector are properly connected to the same local area network.
Configuring the Lan Control Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end to
the RJ45 port.
2. Press MENU/EXIT and then press
3. Press
to highlight Lan Control Settings and press ENTER. The Lan Control Settings page is
displayed.
4. Press
to highlight Control By and press
5. Press
to highlight DHCP and press
6. Press
to highlight AMX Device Discovery and press
Discovery is On, the projector can be detected by AMX controller.
7. Press
to highlight Apply and press ENTER.
8. Please wait for around 15 - 20 seconds, and then re-enter the Lan Control Settings page.
9. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings will be displayed.
Note down the IP address displayed in the Projector IP Address row.
If the Projector IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
to highlight DHCP and press
3. Contact your ITS administrator for information on the Projector IP Address,
Gateway, and DNS Server settings.
4. Press
to select the item you want to modify and press ENTER.
5. Press
/
to move the cursor and then press
6. To save the setting, press ENTER. If you do not want to save the setting, press MENU/EXIT.
7. Press
to highlight AMX Device Discovery and press
8. Press
to highlight Apply and press ENTER.
settings are not available.
/
until the Advanced Setup menu is highlighted.
/
to select
/
to select On.
/
to select Off.
/
.
RJ45
/
to select On or Off. When AMX Device
to enter the value.
/
to select On or Off.
, Default
Subnet Mask
37
Using the projector
Advertisement
Table of Contents
