Auth-Port - Dell PowerConnect 6224 Command Line Interface Manual

Default Configuration
The default value of the port number is 1813.
Command Mode
Radius (accounting) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets port number 56 for accounting requests.
console(config)#radius-server host acct 3.2.3.2
console(Config-acct-radius)#acct-port 56

auth-port

Use the auth-port command in Radius mode to set the port number for
authentication requests of the designated Radius server.
Syntax
auth-port-number
auth-port
auth-port-number — Port number for authentication requests. (Range: 1 -
•
65535)
Default Configuration
The default value of the port number is 1812.
Command Mode
Radius mode
User Guidelines
The host is not used for authentication if set to 0.
User must enter the mode corresponding to a specific Radius server before
executing this command.
RADIUS Commands
501