Dell OptiPlex E1 Reference And Installation Manual page 86

5-4 Dell OptiPlex E1 Managed PC Reference and Installation Guide
 5HSODFH WKH FRYHU
Facing the left side of the computer, hold the cover at a slight angle as shown in
Figure 5-3. Fit the three cover hooks into the rectangular slots on the chassis. (It
may be helpful to look down into the chassis to verify that the hooks are in place.)
Pivot the cover down toward the back and into position. Make sure that the
release buttons click into place.
NOTE: The computer should be placed entirely on a flat surface. It is difficult to
align the cover if the front of the computer is hanging over the edge of a table.
ledge
)LJXUH  5HSODFLQJ WKH &RPSXWHU &RYHU
 ,I \RX DUH XVLQJ WKH RSWLRQDO IORRU VWDQG UHDWWDFK LW
See "Using the Optional Stand for Vertical Orientation" in Chapter 1 for
instructions.
 ,I \RX DUH XVLQJ D SDGORFN WR VHFXUH \RXU V\VWHP UHLQVWDOO WKH SDGORFN
 &OHDU WKH FKDVVLV LQWUXVLRQ DOHUW PHVVDJH
Enter the System Setup program and reset Chassis Intrusion to Not Detected.
See "Chassis Intrusion" in Chapter 2 for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
hooks in slots (3)