Dell OptiPlex E1 Reference And Installation Manual page 130

Can't open index
file. This file is
required for ICU to
run.
No Configuration
Manager.
At least one Plug
and Play card in
your system is not
configured due to
conflicts. These
are marked "config
err" in the list of
configured cards.
Due to conflicts,
the ICU could only
configure some Plug
and Play cards in
your system. Un-
configured cards
are marked "config
err" in the list of
configured cards.
This device is
unconfigurable
because of a
resource conflict
with card
card_name . The con-
flicting resource
is resource_name .
To fix, reconfigure
the conflicting
card.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide .
B-2 Dell OptiPlex E1 Managed PC Reference and Installation Guide
FRQWLQXHG
The ICU cannot find the
index file for its database.
The device driver needed
by the ICU is corrupted or
is not correctly
configured.
The Configuration Man-
ager or the ICU cannot
configure at least one
Plug and Play expansion
card because of resource
conflicts with one or
more cards.
The selected card is un-
configurable because one
of its resources is already
being used by another
device.
Make sure to switch to drive A before attempting
to start the utility.
Verify that the following device statement appears
in your config.sys file:
device= drive :\ directory \drivers\dos\
dwcfgmg.sys
In this statement, drive and directory represent the
drive and directory where the driver resides. The
default is c:\plugplay.
You must reconfigure the conflicting card(s). To
find the conflicting card, perform the following
steps:
config err
The Card Configuration dialog box displays the
functions assigned to the Plug and Play expan-
sion card.
Perform the following procedure:
resource_name
card_name