Dell OptiPlex E1 Reference And Installation Manual page 133

The configuration
(.cfg) file used by
the ICU for this
card is now invalid
or does not exist.
Do you wish to load
the file?
No configuration
(.cfg) file exists
for the card being
modified. Do you
want to load one?
This is an EISA
system. Use an ECU,
not the ICU, to
configure your
system.
You have added a
card using settings
different from fac-
tory default.
Reconfigure the
card to the set-
tings in the next
display (see the
card's manual)
before installing
it.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide .
FRQWLQXHG
This message appears
when you try to add a
listed card and the config-
uration file for this card
has been corrupted or
deleted from the data-
base.
This message appears
when you modify a card
and its configuration file
does not exist or has
been deleted.
This message appears if
you attempt to run the
ICU on an EISA system.
This message can appear
in two situations:
You added an ISA
expansion card,
selected OK, and the
ICU had to use
resource values dif-
ferent from the
card's defaults to
avoid conflicts.
You added an ISA
expansion card,
selected Advanced,
and chose resource
values different from
the card's defaults.
You can get a copy of the configuration file from
the original ISA Configuration Utility Diskette that
you used to create the backup ICU diskette. Use
the following procedure:
8WLOLW\ 'LVNHWWH
GE
For example, type cd a:\db.
The name of the configuration file is part of
this card ID. For example, if the card ID is
ICU0200, the configuration file is !icu0200.cfg.
To use the ICU, you must load the utility onto a
non-EISA system.
Make note of the new card configuration shown in
the Card Resource Usage dialog box displayed
after this message. Change jumper settings on the
ISA expansion card to match the new card
configuration.
ISA Configuration Utility Messages
,6$ &RQILJXUDWLRQ
LFXQG[
B-5