Dell OptiPlex E1 Reference And Installation Manual page 30

1-10 Dell OptiPlex E1 Managed PC Reference and Installation Guide
Dell offers an optional stand that you can attach to the computer for a mini tower (ver-
tical) orientation. Although you can attach (and remove) the stand at any time with a
minimum of system disruption, it is easiest to attach before you set up your computer
and connect the back-panel cables.
Attach the stand as follows:
Position the stand as shown in Figure 1-3. Align the large round hole in the stand
with the securing button on the side of the cover, and align the captive thumb-
screw in the stand with the screw hole in the cover.
locator pin
(on underside
of floor stand)
As you lower the stand into place, make sure that the locator pin (see Figure 1-3)
fits into the corner hole of the hole pattern as shown. When the stand is in place,
tighten the thumbscrew.
To remove the stand, turn the computer over so the stand is at the top, loosen the
screw and lift the stand away, and place the computer in a horizontal position.
captive screw
locator
hole
securing
button