Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for the ASCII character
that will trigger the delay
Delay Length
To remove this delay, scan the Delay Length barcode, and set the number of steps to 0. Scan the Save
barcode using the
Programming Chart
Interfunction Delay
An interfunction delay of up to 495 milliseconds (in 5 ms steps) may be placed between the transmission
of each segment of the message string. Scan the Interfunction Delay barcode below, then scan the
number of 5 millisecond steps (0-99), and the Save barcode using the
back cover of this manual.
To remove this delay, scan the Interfunction Delay barcode, then set the number of steps to 0. Scan
the Save barcode using the
Intermessage Delay
An intermessage delay of up to 495 milliseconds (in 5 ms steps) may be placed between each scan
transmission. Scan the Intermessage Delay barcode below, then scan the number of 5 millisecond
steps (0-99), and the Save barcode using the
To remove this delay, scan the Intermessage Delay barcode, then set the number of steps to 0. Scan
the Save barcode using the
ASCII Conversion Chart (Code Page
inside the back cover of this manual.
Prefix
STX
1
HT
Interfunction Delays
Interfunction Delay
Programming Chart
Programming Chart
1st Scan Transmission
Intermessage Delay
Intermessage Delay
Programming Chart
1252), page A-3.
Scanned Data
Suffix
2 3 4 5
CR
LF
inside the back cover of this manual.
inside the back cover of this manual.
2nd Scan Transmission
inside the back cover of this manual.
Character to Trigger Delay
Programming Chart
inside the
4 - 5