Connecting The Document Reader With Ttl-232 Serial Port - Honeywell 4800dr - Document Camera Barcode Manual

1. Connect the appropriate interface cable to the document reader first, then to the computer.
2. Program the document reader for a USB interface using the Plug and Play barcodes beginning on
page 1-3.
3. The document reader beeps.
4. Verify the document reader operation by scanning a barcode from the
of this manual.
For additional USB programming and technical information, refer to Honeywell "USB Application Note,"
available at www.honeywell.com/aidc.

Connecting the Document Reader with TTL-232 Serial Port

Note: See "Document Reader Models"
document reader.
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the document reader.
Note: For the document reader to work properly, you must have the correct cable for your type of
terminal/computer.
3. Plug the serial connector into the serial port on your computer. Tighten the two screws to secure the
connector to the port.
1 - 2
on page 1-1 to determine which interfaces apply to your
Sample Symbols in the back