User Specified Intercharacter Delay; Interfunction Delay - Honeywell Voyager XP 147 Series User Manual

To remove this delay, scan the Intercharacter Delay barcode, then set the number
of delays to 0. Scan the Save barcode using the
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length barcode below, then scan the number of 5ms delays, and the Save
barcode using the
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for a
printable character to trigger the delay See
Replacements
To remove this delay, scan the Delay Length barcode, and set the number of delays
to 0. Scan the Save barcode using the

Interfunction Delay

An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each segment of the message string. Scan the
Interfunction Delay barcode below, then scan the number of 5ms delays, and the
Save barcode using the
To remove this delay, scan the Interfunction Delay barcode, then set the number
of delays to 0. Scan the Save barcode using the
Voyager XP User Guide
Programming
on page A-220..
Delay Length
Programming
Chart.
ISO 2022/ISO 646 Character
Programming
Chart.
Prefix Scanned Data
STX 1 HT 2 3 4 5
Interfunction Delays
Interfunction Delay
Programming Chart.
Character to Trigger Delay
Chart.
Suffix
CR LF
Programming Chart.
97