Visual Xpress Introduction - Honeywell 4800dr - Document Camera Barcode Manual

or by scanning the following barcode:
Note: The PQA report is sent out as a second data/beep sequence after the barcode data. The report
has its own Honeywell code ID of >(0X3E) so it can be uniquely identified.
You can exit Full Report mode by either typing the menu command, 2D_PQA0, if you are using
Quick*View, or by scanning the following barcode:
Note: For additional information on interpreting your read results, please refer to Honeywell's Quick
Check 2D Print Assessment User's Guide.

Visual Xpress Introduction

Visual Xpress provides a wide range of PC-based programming functions that can be performed on a
document reader connected to your PC's COM port. Visual Xpress allows you to download upgrades to
the document reader's firmware, change programmed parameters, and create and print programming
barcodes. Using Visual Xpress, you can even save/open the programming parameters for a document
reader. This saved file can be e-mailed or, if required, you can create a single barcode that contains all
the customized programming parameters and mail or fax that barcode to any location. Users in other
locations can scan the barcode to load in the customized programming.
To communicate with a document reader, Visual Xpress requires that the PC have at least one available
serial communication port, or a serial port emulation using a physical USB port. If you are using the
serial port and TTL-232 cable, an external power supply is required. When using a USB serial port emu-
lation, only a USB cable is required.
Visual Xpress Operations
The Visual Xpress software performs the following operations:
Scan Data
Scan Data allows you to scan barcodes and display the barcode data in a window. Scan Data lets you
send serial commands to the document reader and receive document reader response that can be seen
in the Scan Data window. The data displayed in the Scan Data window can either be saved in a file or
printed.
Configure
Configure displays the programming and configuration data of the document reader. The document
reader's programming and configuration data is grouped into different categories. Each category is dis-
played as a tree item under the "Configure" tree node in the application explorer. When one of these
tree nodes is clicked, the right-hand side is loaded with the parameters' form belonging to that particular
category. The "Configure" tree option has all the programming and configuration parameters specified
for a document reader. You can set or modify these parameters as required. You can later write the
modified settings to the document reader, or save them to a dcf file.
Full Report
Exit
9 - 3