Carriage Motor (Cr Motor) Assembly Removal - Epson Stylus COLOR 800 Service Manual

EPSON Stylus &2/25 800

3.10 Carriage Motor (CR Motor) Assembly Removal

1. Remove the upper housing. (See Section 3.4.)
2. Release the CR lock lever using tweezers. Then shift the CR assembly from the capping
position manually.
3. Remove 2 screws (CBS, 3x6, F/Zn) securing the CR motor assembly to the top frame. (See
Figure 3-19.)
Figure 3-19. Screws Securing the CR Motor Assembly
4. Disengage the timing belt from the pinion gear.
5. Unlock CN12 on the C202 MAIN board by pulling up the lock lever. Then disconnect the CR
motor connector cable from CN12.
6. Remove the CR motor assembly from the printer mechanism.
When mounting the CR motor assembly to the top frame, insert the CR motor cable
facing the bottom of the printer, and fit the CR motor assembly pins into the cutout in the
top frame.
Tightening torque for the screws (CBS, 3x6, F/Zn) = 8 ~ 10 kg-cm.
Perform the Bi-d adjustment after reinstalling the CR motor assembly. See Chapter 4.
3-18
REQUIRED ADJUSTMENT
Rev. A