Bezel Blanks
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the front bezel
4.
Gently pull the subpanel, with the bezel blanks secured in it, away from the front bezel, then remove
the desired bezel blank.
CAUTION:
away at an angle could damage the pins that align it within the front bezel.
Figure 7-10
NOTE:
When replacing the subpanel, ensure that the aligning pins and any remaining bezel blanks
are in their proper orientation. The logo on the subpanel should be located at the bottom of the subpanel
when properly oriented.
72
Chapter 7 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis
(Front Bezel on page
Hold the subpanel straight when you pull it away from the front bezel. Pulling the subpanel
Removing Bezel Blanks from the Subpanel (Desktop Shown)
(Preparation for Disassembly on page
(Computer Access Panel on page
71).
63).
70).