Heatsink - HP dc7900 - Convertible Minitower PC Service & Reference Manual

Heatsink

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the fan shroud
4. Remove the chassis fan
5. Loosen the four captive screws that secure the heatsink to the system board tray.
CAUTION:
X) to even the downward forces on the processor. This is especially important as the pins on the
socket are very fragile and any damage to them may require replacing the system board.
6. Lift the heatsink from atop the processor and set it on its side to keep from contaminating the work
area with thermal grease.
Figure 8-62
When reinstalling the heatsink, make sure that its bottom has been cleaned with an alcohol wipe and
fresh thermal grease has been applied to the top of the processor.
CAUTION:
evenly seat the heatsink on the processor to avoid damage that could require replacing the system
board.
Failure to install the fan shroud may cause the computer to overheat.
(Computer Access Panel on page
(Fan Shroud on page
(Front Fan Assembly on page
Heatsink retaining screws should be removed in diagonally opposite pairs (as in an
Removing the heatsink
Heatsink retaining screws should be tightened in diagonally opposite pairs (as in an X) to
(Preparation for Disassembly on page
161).
162).
118).
125).
Heatsink 167