Maytag MEDB700VQ - R BravosR Electric Dryer Use And Care Manual page 8

EII](]YFIQII (}I [I.;(iil.l B - _._0o0_ _.o '_,_,=I} 7
I>II!_I_ZI II_II
Power Supply Cord Direct Wire
Fire Hazard
Use a new UL listed 30 amp power supply cord.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Fire Hazard
Use 10 gauge sold copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten al electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Style 1 : Power supply cord strain relief
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
AB C D
A. Terminal block cover
B. HoM-down screw location
C. External ground conductor
screw
D. Centel, silver-colored
terminal block screw
E. Neutral ground wire
£ Hole below terminal block
opening
3. Install strain relief.
Remove the screws from a s/4" (1.9 cm) UI_ listed strain relief (UL marking on strain relief).
Put the tabs of the two clamp sections into the hole below the terminal block opening so
that one tab is pointing up and the other is pointing down, and hold in place. Tighten
strain relief screws just enough to hold the two clamp sections together.
: .... ;................................ / ............................................ A
A. Strain relief tab pointing up
B. Hole below terminal [)lockopening
C. Clamp section
D. Strainrelief tab pointing down
8