Changing Cycles, Modifiers, And Options - Maytag MEDB700VQ - R BravosR Electric Dryer Use And Care Manual

Lint on load
Is the exhaust vent diameter the correct size?
Use 4" (10.2 cm) diameter vent material.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
Is the dryer located in a room with temperature below 45°F (7°C)?
Proper operation of dryer cycles requires temperatures above 45°F (7°C).
Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and bottom of the door. The rear of
the dryer requires 5" (12.7 cm) of airspace, and the sides and front of the dryer require a
minimum of 1" (2.5 cm). See the Installation Instructions.
Has the Air Fluff modifier been selected?
Select the right temperature for the types of garments being dried. See "Modifiers."
Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Are all your Sensor cycle loads consistently not as dry as you would like?
You may change the preset Dryness I.evel settings to increase dryness for all Sensor cycles.
See "Changing Cycles, Modifiers, and Options."
Cycle time too short
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
Is the sensor cycle ending early?
The load may not be contacting the sensor strips. I.evel the dryer.
Change the dryness [eve[ setting on Sensor Cycles. Increasing or decreasing the dryness
[eve[ will change the amount of drying time in a cycle.
•
Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains on load or drum
Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added
to a partially dried load can stain your garments.
Drum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to
other clothing.
Loads are wrinkled
•
Was the load removed from dryer at the end of the cycle?
• Was the dryer overloaded?
I)ry smaller loads that can tumble freely.
Odors
Have you recently been painting, staining, or varnishing in the area where your dryer is
located?
If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry
the clothing.
Is the dryer being used for the first time?
The new electric heating element may have an odor. The odor will be gone after the first
cycle.
30