Maytag MEDB700VQ - R BravosR Electric Dryer Use And Care Manual page 10

3o
4-wire connection: Power supply cord
IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do
not permit the use of 3-wire connections.
A_....._ B
F
C D E G
A. 4-wire receptacle (NEMA type 14-30R)
B. 4-prong plug
C. Cround prong
D. Neutral prong
E.Spade terminals with upturned ends
I: 3/4" ( 1.9 cm) UL listed strain relief
C. Ring terminals
Remove center silver-colored terminal block screw.
Remove neutral ground wire from external ground conductor screw. Connect neutral
ground wire and the neutral wire (white or center wire) of power supply cord under
center, silver-colored terminal block screw. Tighten screw.
B
1o
2.
A
D
/
E
A. Neutral ground wire
B. External ground conductor screw - Dotted line shows position
of NLUTRAL ground wire before being moved to center silver-
colored terminal block screw.
C. Center silver-colored terminal bkJck screw
D. Neutral wire (white or center wire)
E. Y4" ( 1.9 cm) UL listed strain relief
Connect ground wire (green or bare) of power supply cord to external ground conductor
screw. Tighten screw.
A
G
L
F
A. External ground conductor screw
B. Neutral ground wire
C. Cround wire (green or bare) of power supply cord
D. Y4" ( 1.9 cm) UL fisted strain refief
E. Center silver-colored terminal block screw
f: Neutral wire (white or center wire)
4. Connect the other wires to outer terminal block screws. Tighten screws.
! !
5. Tighten strain relief screws.
6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
7. You have completed your electrical connection. Now go to "Venting Requirements."
I 0