Epson EPL-6200 Reference Manual page 56

Installing the printer driver for the USB interface
Follow the steps below to install the PostScript printer driver for
the USB interface:
Note:
The USB interface is not available for printing under Windows 95.
If the Windows driver and the Adobe PS driver for an Epson printer
with a USB connection have already been installed on your
computer, follow the installation procedure explained in the
previous section, "Driver installation for the parallel interface
connection," but make sure to select USB as the port in step 7. If
you have not installed an Epson USB printer driver on your
computer, follow the installation procedure below.
You must have at least 6 MB of free space on your hard disk drive
to install the PostScript printer driver.
1. Without connecting the printer to your computer, turn on
both the computer and the printer.
2. Once Windows has started, connect your computer to the
printer with a USB cable.
3. The Add New Hardware Wizard will launch automatically.
Click Next to start the installation of the USB printer driver.
4. Select Search for best driver for your device
(Recommended), and then click Next.
5. Insert the CD-ROM that shipped with your printer into the
CD-ROM drive.
6. Select only the Specify a location check box, and then
specify the following path on the CD-ROM. You can click
Browse to select the path. If your CD-ROM drive is D:, the
path will be D:\AdobePS\english\win9x\ps_setup
(change the drive letter as needed for your system).
Using the Printer Driver For Windows
3
3
3
3
3
3
3
3
3
3
3
3
39