Table of Contents
Advertisement
REMOTE IN terminal
Using the [REMOTE IN] terminal provided on the connection terminals of the main unit, it is possible to operate
the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot
be received.
Projector set up in a meeting room
Pin assignments and control
J
D-Sub 9-pin (Outside view)
Attention
Be sure to short-circuit Pins
z
When pin
and pin
are short-circuited, the following buttons on the projector's control panel and on the remote control
z
cannot be used.
<POWER (
)> button, <AV MUTE> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
When pin
and pin
are short-circuited and then any one of pins
z
on the projector's control panel and on the remote control cannot be used.
<POWER (
)> button, <INPUT SELECT> buttons (RGB1, RGB2, DVI-D, VIDEO/S-VIDEO, NETWORK, HDMI),
<AV MUTE> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
The above is explanation in the case where
z
"STANDARD".
Pin No.
Signal name
POWER
S-VIDEO
AV MUTE
RST/SET
and
when controlling.
"REMOTE MODE" of "PROJECTOR SETUP" (
Technical Information
Remote control
Remote control/External control
Standby
RGB1
RGB2
DVI-D
Control panel located in a different room
Open (H)
GND
—
OFF
RGB1
Other
RGB2
Other
VIDEO
Other
Other
DVI-D
Other
OFF
Controlled by
remote control
to
is short-circuited to pin
External control
ON
LAMP
VIDEO
S-VIDEO
Short (L)
GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
DVI-D
ON
Controlled by
external contact
, the following buttons
Æ
page 66) is set to
ENGLISH -
85
Hide quick links:
Advertisement
Table of Contents
