Rgb In (Only Rgb Input); Dvi-D In; Hdmi In - Panasonic PT-DW530U Operating Instructions Manual

RGB IN
(Only RGB input)
Change this setting to change the input impedance of
the synchronous signal input.
1 ) Press ▲▼ to select [RGB IN].
2 ) Press <ENTER> button.
The [ RGB IN] screen will be displayed.
z
3 ) Press ▲▼ to select [RGB1 SYNC
TERMINAL] or [RGB2 SYNC
TERMINAL].
4 ) Press ◄► to switch.
The setting will change as follows each time
z
◄► is pressed.
LOW
LOW Input impedance is set to [LOW].
HIGH Input impedance is set to [HIGH].

DVI-D IN

Change this setting if video does not display normally
when the projector and an external device are
connected via DVI.
1 ) Press ▲▼ to select [DVI-D IN].
2 ) Press <ENTER> button.
DVI-D IN] screen will be displayed.
The [
z
3 ) Press ▲▼ to select [DVI EDID].
4 ) Press ◄► to switch [DVI EDID].
The setting will change as follows each time
z
◄► is pressed.
EDID3 EDID1
Switch between fine settings for a
EDID3
moving image and for a still image.
Mainly select this when an external
device (DVD player, etc.) for
EDID1 outputting video signals of a moving
image system is connected to DVI-D
IN.
Mainly use this when an external
device (PC, etc.) for outputting video
EDID2 : PC
signals of a still image system is
connected to DVI-D IN.
5 ) Press ▲▼ to select [DVI SIGNAL
LEVEL].
6 ) Press ◄► to switch [DVI SIGNAL
LEVEL].
z
0-255 : PC
0-255 : PC
16-235
Note
HIGH
The optimal setting differs depending on the output
z
setting of the connected external device. Refer to the
instruction manual of the external device.
If the setting is changed, the data for plug and play
z
changes. For the plug and play compatible resolutions,
refer to "List of compatible signals" (

HDMI IN

Change this setting if video does not display normally
when the projector and an external device are
connected via HDMI.
1 ) Press ▲▼ to select [HDMI IN].
2 ) Press <ENTER> button.
z
3 ) Press ◄► to switch [HDMI SIGNAL
LEVEL].
z
EDID2 : PC
0-1023
64-940
Note
The optimal setting differs depending on the output
z
setting of the connected external device. Refer to the
instruction manual for the external device.
The displayed HDMI signal level is the value when the
z
input is 30 bit.
DISPLAY OPTION menu
The setting will change as follows each time
◄► is pressed.
Select this when, for example,
an external device (PC, etc.) is
connected via the DVI terminal
output.
Select this when, for example, an
external device (DVD player, etc.)
is connected via the HDMI terminal
output using a conversion cable.
The [ HDMI IN] screen will be displayed.
The setting will change as follows each time
◄► is pressed.
0-1023
Select this when, for example, a DVI
terminal output of an external device
(PC etc.) is connected to HDMI IN
using a conversion cable, etc.
Select this when, for example,
an HDMI terminal output of an
external device (DVD player, etc.) is
connected to HDMI IN.
16-235
Æ page 87).
64-940
57
ENGLISH -