Status; Date And Time - Panasonic PT-DW530U Operating Instructions Manual

STATUS

Displays the status of the projector.
1 ) Press ▲▼ to select [STATUS].
2 ) Press <ENTER> button.
3 ) Press ◄► to move to the next page.
Displays the input selection
INPUT
state.
SIGNAL NAME Displays the input signal name.
SIGNAL
Displays the frequency of the
FREQUENCY input signal.
PROJECTOR
Displays the projector runtime.
RUNTIME
ECO:
z
LAMP POWER: Shows the
lamp lighting time in ECO
mode.
NORMAL:
z
LAMP LAMP POWER: Shows the
lamp lighting time in NORMAL
operation.
TOTAL:
z
Shows the total lamp lighting
time.
INTAKE Displays the intake air
AIR TEMP. temperature of the projector.
OPTICS Displays the temperature inside
MODULE TEMP. the projector.
AROUND Displays the temperature around
LAMP TEMP. the lamp of the projector.
NUMBER OF Displays the number of
ENTRY SIGNAL registered signals.
REMOTE Displays [REMOTE] control
STATUS status.
PROJECTOR
Displays type of projector.
TYPE
SERIAL Displays the serial number of the
NUMBER projector.
LAMP UNIT Displays the component number
MODEL NO.
of the lamp unit.
LAMP SERIAL Displays the serial number for
NUMBER lamp.
Displays the main version of the
MAIN VERSION
firmware of the projector unit.
Displays the sub version of the
SUB VERSION
firmware of the projector unit.
NETWORK Displays the network version of
VERSION the projector unit.
EMULATE Displays the set emulate mode.
PROJECTOR SETUP menu
POWER ON TIMES :
z
Displays the number of times
the power has been turned
ON COUNT on.
LAMP ON :
z
Displays the number of times
LAMP has been lit.
*1 :
Lamp replacement time =
LAMP POWER [NORMAL] lighting time
+ (LAMP POWER [ECO] lighting time x 2 ÷ 3)

DATE AND TIME

This lets you set the time zone and the current date
and time for the projector's internal clock.
Setting the TIME ZONE
J
1 ) Press ▲▼ to select [DATE AND TIME].
2 ) Press <ENTER> button.
3 ) Press ▲▼ to select [TIME ZONE].
4 ) Press ◄► to switch [TIME ZONE].
Adjusting the date and time
J
manually
1 ) Press ▲▼ to select [DATE AND TIME].
2 ) Press <ENTER> button.
3 ) Press ▲▼ to select [ADJUST CLOCK].
4 ) Press <ENTER> button.
The [ADJUST CLOCK] screen will be displayed.
z
5 ) Press ▲▼ to select the item to be set,
and press ◄► to set the local time.
6 ) Press ▲▼ to select [APPLY], and
press <ENTER> button.
This completes setting of the time.
z
67
ENGLISH -