Communication (Network, Lan Setup) - DREAM MULTIMEDIA Dreambox DM7020S Manual

35.1. Communication (Network, LAN Setup)

Press the MENU-Button to enter the OSD-Main menu.
Go to (6) Setup -> (6) Expert Setup -> select Communication Setup.
Attention:
If you are using a DHCP Server in your LAN, configure
the DHCP Server so as not to assign an IP-Address
which the Dreambox is using. The Dreambox does
currently not support DHCP. Otherwise an IP-Address
collision is possible. Refer to the DHCP Server Manual
about how to configure a DHCP-Address-Pool.
Use the Navigation-Buttons and the Numeric-
Keyboard to set the Values.
IP:
Enter the IP-Address here. The IP-Address is used
to specify the Host IP-Address.
Netmask:
Enter the Netmask here. The Netmask is used to
find an Host IP-Address in its Subnet.
Type:
LAN (Local Area Network); Connection to the home
Network. Default is LAN.
WAN/PPPoE (Wide Area Network) / (Point-to-Point
Protocol over Ethernet); Direct Connection to the
Internet, (e.g. DSL Modem direct connected to the
Dreambox). Please proceed to next passage for
WAN settings.
Nameserver:
Enter the DNS-Server IP-Address here. DNS is used
to translate a Domain name to an IP-Address.
Normally, if the Type is set to LAN, there is no need
for a DNS entry. If the Dreambox is connected to the
Internet over a Router, enter the Router
here.
Gateway:
Enter the Router
is connected to the Internet over a Router.
Configure Network:
Setting a check enables the Network. Default is
disabled.
Port 80:
Enter a Port of your choice to configure the HTTP
Port for the Dreambox Web Interface. Default is Port
80.
- 37 -
'
s IP-Address here, if the Dreambox
'
s IP-Address