Satellite Configuration - DREAM MULTIMEDIA Dreambox DM7020S Manual

18. Satellite Configuration

Press the MENU-Button to enter the OSD-Mainmenu.
Go to (6) Setup -> (2) Service Searching -> (1) Satellite Configuration.
19. Satfind
Press the MENU-Button.
Go to (6) Setup -> (2) Service Searching -> (2) Satfind.
Navigate to the upper Dropdown list and choose your
appropriate Satellite Configuration and press the OK-
Button. Choose your Satellites the Dish is adjusted to
and press the green Option-Button to save
configuration.
This Configuration might differ from yours.
Choose from the lower Dropdown lists your preferred
satellite and transponder.
Adjust the Dish towards the desired satellite until you
have a high value on the Signal strength AGC and on
the Signal quality SNR indicator. The BER should
always indicate a value of zero if the Satellite is locked
and synced.
SNR: Signal to Noise Ratio
This Indicator shows the Quality of the Signal.
AGC: Automatic Gain Control
This Indicator shows the Strengh of the Signal.
BER: Bit Error Rate
This Indicator shows the Errors Rate of the Signal.
- 20 -