Table of Contents
Advertisement
To place a project cue using the Preview window:
1. Click Play [
ENTER
the Navigation bar to move to the place where you want to add a cue.
2. Press [
5] on your keyboard when you want to add a cue (or click the
F
Menu button and choose Add/Delete Cue).
3. Cues (blue triangles) appear on the Timeline Cue bar.
Note: See Placing clip cues below for how to place clip cues from the Source window.
The default name of the clip (the variable &p) is the location of the cue on
the Timeline. For example, the default name of a cue at the 1 minute, 30
second point would be '01:30:00'. Right-click a cue to view its name. If
you wish to move a cue, drag it to a new location. To remove a cue, drag
it off the edges of the Timeline. Click View: Cue Manager to delete cues,
rename them or jump to a specific cue.
Placing clip cues
You can also place cues on individual clips. In this case, the cues are black
and appear on the Timeline immediately below the clip. These cues cannot
be named but can be used as navigation points in the Source window by
clicking the Next/Previous Edit Point buttons.
To place clip cues using the Source window:
1. Open a clip in the Source window (double-click the clip or drag it to the
Source Window).
2. Play the clip or use the Navigation bar to move to the place where you
want to place a cue.
3. Press [
5] (or click the Menu button and choose Add/Delete Cue).
F
4. Continue adding cues and click the Apply button when finished.
To view clip cues on the Timeline:
1. Click View: Timeline Display Mode or the Timeline Display Mode
button.
2. Select Show cue bar for video and/or audio tracks.
Note: Project cues are always visible at the top of the Timeline.
VIDEO EDITOR: CHAPTER TWO
] to preview the project in the Preview window or use
161
Advertisement
Table of Contents
