Configuring Persistent Logging Options - Cisco AP541N-A-K9 Administration Manual

Administration
Event Logs
NOTE
WARNING
Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide
Click Refresh to refresh the page.
The access point acquires its date and time information using the network time
protocol (NTP). This data is reported in UTC format (also known as Greenwich Mean
Time). You need to convert the reported time to your local time. For information on
setting the network time protocol, see
page 46.

Configuring Persistent Logging Options

If the system unexpectedly reboots, log messages can help you diagnose the
cause. However, log messages are erased when the system reboots unless you
enable persistent logging.
Enabling persistent logging can wear out the flash (non-volatile) memory and
degrade network performance. You should only enable persistent logging to debug
a problem. Make sure you disable persistent logging after you finish debugging the
problem.
To configure persistent logging on the Event Logs page, set the persistence,
severity, and depth options as described in
Figure 29 Persistent Logging Options
Enabling the Network Time Protocol,
Table 31, and then click Apply.
6
128