Wireless
Configuring the Wireless Distribution System
Figure 18 Configuring WDS Bridge Settings
Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide
Before you configure WDS on the access point, note the following guidelines:
When using WDS, be sure to configure WDS settings on both access points
•
participating in the WDS link.
•
You can have only one WDS link between any pair of access points. That is,
a remote MAC address might appear only once on the WDS page for a
particular access point.
•
Both access points participating in a WDS link must be on the same
wireless radio channel and use the same IEEE 802. 1 1 mode. (See
Modifying Advanced Settings, page 79
Radio mode and channel.)
for information on configuring the
4
92