Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Quick Start Manual
  1. Manuals
  2. Brands
  3. Cisco Manuals
  4. Wireless Access Point
  5. AIR-AP1010 - 1000 Series Lightweight Access...
  6. Quick start manual
Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Quick Start Manual

Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Quick Start Manual

Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
AP1010 Cisco Aironet 1000 Series IEEE
802.11a/b/g Lightweight Access Points
with Internal Antennas - Quick Start Guide
Corporate Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: 408 526-4000
800 553-NETS (6387)
Fax: 408 526-4100
Text Part Number: 78-17146-01

Advertisement

Table of Contents
loading

Related Manuals for Cisco AIR-AP1010 - 1000 Series Lightweight Access Point

Summary of Contents for Cisco AIR-AP1010 - 1000 Series Lightweight Access Point

  • Page 1 AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide Corporate Headquarters Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 http://www.cisco.com Tel: 408 526-4000 800 553-NETS (6387) Fax: 408 526-4100...
  • Page 2 You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures: •...

  • Page 3: Table Of Contents

    Projection Wall Mount Flush Wall Mount Returning MAC Information Planning Notes A P P E N D I X Cables External Antennas Mounting Options AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...
  • Page 4 EU Regulatory Information Industry Canada Required User Information for Cisco Aironet 1000 Series Lightweight Access Points Safety Considerations N D E X AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...
  • Page 5 Pre-Installation Configuration, page 3 • • Preparing Mounting Locations, page 5 Mounting the Access Points, page 7 • • Returning MAC Information, page 13 AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...

  • Page 6: Preface

    You can access the most current Cisco documentation at this URL: http://www.cisco.com/univercd/home/home.htm You can access the Cisco website at this URL: http://www.cisco.com You can access international Cisco websites at this URL: http://www.cisco.com/public/countries_languages.shtml AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...

  • Page 7: Documentation Dvd

    Cisco Systems Attn: Customer Document Ordering 170 West Tasman Drive San Jose, CA 95134-9883 We appreciate your comments. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...

  • Page 8: Cisco Product Security Overview

    PSIRT is the one that has the most recent creation date in this public key server list: http://pgp.mit.edu:11371/pks/lookup?search=psirt%40cisco.com&op=index&exact=on In an emergency, you can also reach PSIRT by telephone: 1 877 228-7302 • 1 408 525-6532 • AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide viii 78-17146-01...

  • Page 9: Obtaining Technical Assistance

    Cisco TAC engineer. The TAC Service Request Tool is located at this URL: http://www.cisco.com/techsupport/servicerequest For S1 or S2 service requests or if you do not have Internet access, contact the Cisco TAC by telephone. (S1 or S2 service requests are those in which your production network is down or severely degraded.) Cisco TAC engineers are assigned immediately to S1 and S2 service requests to help keep your business operations running smoothly.

  • Page 10: Definitions Of Service Request Severity

    You can access Packet magazine at this URL: http://www.cisco.com/packet AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...
  • Page 11 You can access the Internet Protocol Journal at this URL: http://www.cisco.com/ipj • World-class networking training is available from Cisco. You can view current offerings at this URL: http://www.cisco.com/en/US/learning/index.html AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...
  • Page 12 Preface Obtaining Additional Publications and Information AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...

  • Page 13: Installation And Configuration

    LAN Solution, and require no manual configuration after they are mounted. Overview This document assumes that a site survey has been performed as described in the Cisco 1000 Series IEEE 802.11a/b/g Lightweight Access Point Deployment Guide, that AP locations and mounting options have been selected, and that you have one AP per indicated location.

  • Page 14: Important Guidelines

    IP segment, it attempts to join a Cisco Wireless LAN Controller. If it is unable to join a Cisco Wireless LAN Controller after a number of attempts, it does an arp for the default configured gateway. If the AP is on the wrong subnet, it will not be able to resolve the gateway arp and it will attempt to contact a DHCP server.

  • Page 15: Pre-Installation Configuration

    Material Authorization) procedures. Perform the following procedure on each AP BEFORE deploying it in its final location. Note This procedure assumes that you are preparing a version 3.0 or later APs to operate with a Cisco Wireless Note LAN Controller.
  • Page 16 Set the Cisco Wireless LAN Controller as the Master so that new AP always associate with it. Step 2 Take the AP out of the box and plug it into the same subnet as the Cisco Wireless LAN Controller. Step 3 Apply power to the AP: Use 802.3af-compatible PoE from an orderable inline power injector.

  • Page 17: Preparing Mounting Locations

    SURE that a DHCP server is available on the subnet where you will be installing the AP, and that the subnet has a route back to the Cisco Wireless LAN Controller. Also be sure that the route back to the Cisco Wireless LAN Controller has destination UDP ports 12222 and 12223 open for LWAPP communications.
  • Page 18 1/4 inch (6.35 mm) or smaller heads protruding from the ceiling about 0.1 inch (2.5 mm). Mounting the Access Points” You are now ready to install the AP. Continue with “ AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal 7817146-01...

  • Page 19: Mounting The Access Points

    • Flush Wall Mount, page • Ceiling-Mount Bezel -- Refer to the Ceiling Mount Bezels for Cisco Aironet 1000 Series Lightweight Access Points - Quick Start Guide. Ceiling Mount Base When you are mounting the AP in the middle of a ceiling (flat sides toward the room or hallway), use...

  • Page 20: Ceiling-Mount Clips

    Attach the cables to the sides of the AP. Note When the AP is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the AP is broadcasting its beacon signal(s).
  • Page 21 Be sure the cables are routed away from the AP antennas. Note When the AP is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and Note Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the AP is broadcasting its beacon signal(s).

  • Page 22: Projection Wall Mount

    Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure. Note If the screws do not securely hold the bracket, remove the AP and adjust the screws until they securely hold the bracket. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal 7817146-01...

  • Page 23: Flush Wall Mount

    Note Be sure the cables are routed away from the AP antennas. When the AP is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and Note Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the AP begins broadcasting its beacon signal(s).
  • Page 24 If the screws do not securely hold the bracket, remove the AP and adjust the screws until they securely hold the bracket. Figure 10 Attaching the AP to the Flush-Mount Bracket Attach the cables to the sides of the AP. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal 7817146-01...

  • Page 25: Returning Mac Information

    Note Note When the AP is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the AP begins broadcasting its beacon signal(s). When this happens, complete the installation as quickly as possible to remove yourself from within 8 inches (20 cm) of the AP to comply with FCC RF radiation exposure guidelines.
  • Page 26 Installation and Configuration Returning MAC Information AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal 7817146-01...

  • Page 27: Appendix

    AP, because the AP will receive its power across the CAT-5 Ethernet cable. Return the power supply to the wireless network planner/manager. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...

  • Page 28: External Antennas

    AP. The flush-mount L-bracket is the one with one long and one short leg. Use the L-bracket to mark the sheet metal, drywall, or other screw locations. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...

  • Page 29: Fcc Statements For Cisco Aironet 1000 Series Lightweight Access Points

    FCC certification of this product is not allowed. Installers of the radio and end users of the Cisco Wireless LAN Solution must adhere to the installation instructions provided in this manual.

  • Page 30: Eu Regulatory Information

    Austria - Only transmission within the frequency band 5150-5250 MHz is allowed. The band • 5470-5750 MHz is not allowed. Belgium - The frequency band 5470-5750 MHz is not allowed. • AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...

  • Page 31: Lightweight Access Points

    When used below dropped ceiling use a UL Listed ITE power adapter (QQGQ) marked LPS or a • Listed Direct Plug-in Adapter (EPBU) marked Class 2 with output rated 48 V, 0.4 A. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...
  • Page 32 Se non si è certi della disponibilità di un adeguato collegamento di messa a terra, richiedere un controllo elettrico presso le autorità competenti o rivolgersi a un elettricista. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...
  • Page 33 Om det föreligger osäkerhet huruvida lämplig jordning finns skall elektrisk besiktningsauktoritet eller elektriker kontaktas. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...
  • Page 34 Appendix A Planning Notes AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide 78-17146-01...

  • Page 35: N D E X

    FCC Statements for Cisco Aironet 1000 Series Lightweight Access Points Flush Wall Mount Important Guidelines Mounting Options Mounting the Access Points Obtaining Documentation AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide IN-1 78-17146-01...
  • Page 36 Index AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide IN-2 78-17146-01...

This manual is also suitable for:

Ap1010

Table of Contents