Mounting Plate Attached To A Surface - Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual

Installing the Access Point to the Mounting Plate

Mounting Plate Attached to a Surface

Your access point must have the mounting bracket latch attached to the bottom of the unit.
Note
When the mounting plate is attached to a surface, follow these steps to install the access point to the
mounting plate:
Prior to attaching the access point to the mounting plate, ensure that the radio modules are completely
Step 1
inserted and both module latches are in the locked position (see
Locate the the mounting plate latch opening on your mounting plate (see
Step 2
Position the end of the access point with the mounting plate latch (see
Step 3
the mounting plate with the latch opening.
To assist in aligning the access point to the mounting plate, place the access point on the mounting plate
Step 4
and align the access point side (with the security cable key slot) with the outline on the mounting plate
(see
Figure 2-18
1
Slowly slide the access point over the outline on the mounting plate until the mounting plate latch clicks.
Step 5
Visually verify that the four access point foot pins are securely held by the mounting plate slots.
Step 6
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
2-26
Figure 2-18).
Align Access Point to Mounting Plate Marking
1
Outline on mounting plate
Chapter 2
Figure 2-24).
Figure
Figure 2-16) towards the end of
2
2
Security cable key slot side of access point
Installing the Access Point
2-2).
OL-8247-03