Mounting Plate Attached To A Surface - Cisco AIR-AP1251AG-A-k9 Hardware Installation Manual

Chapter 2 Installing the Access Point

Mounting Plate Attached to a Surface

Note Your access point must have the mounting bracket latch attached to the bottom of the unit.
When the mounting plate is attached to a surface, such as a wall or ceiling, follow these steps to install
the access point to the mounting plate:
Prior to attaching the access point to the mounting plate, ensure that the radio modules are completely
Step 1
inserted andboth module latches are in the locked position (see
Locate the the mounting plate latch opening on your mounting plate (see
Step 2
Position the end of the access point with the mounting plate latch (see
Step 3
mounting plate with the latch opening.
Place the access point on the mounting plate and align the access point side (with the security cable key
Step 4
slot) with the outline on the mounting plate (see
Figure 2-11
1
Slowly slide the access point over the outline on the mounting plate until the mounting plate latch clicks.
Step 5
Visually verify that the four access point feet are securely held by the mounting plate slots.
Step 6
OL-8247-02
C I S C O C O N F I D E N T I A L - D r a f t A 1
Align Access Point to Mounting Plate Marking
1
Outline on mounting plate
Installing the Access Point to the Mounting Plate
Figure 2-11).
2
2
Security cable key slot side of access point
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
Figure 2-16).
Figure 2-2).
Figure 2-9) towards the end of the
2-21